Panasonic 5000 Series Operating Instructions Manual page 180

MANAGER OPERATIONS
System Close (Report 100)
One of reports listed on the Z1 menu is System Close. You can use System Close at the
end of the day to reset all Basic workstations and store the consolidated totals in the
Master. The totals remain in the Master workstation until you perform a System Open.
Use the following procedure for System Close.
1. Turn the keylock at the System Master to MGR Mode.
2. Use the following sequence to advance to the System Close screen.
2
3. The system first checks the Communication Status (the first through last workstations
that are part of your System Close). If the Status screen shown below does not display,
go to Step 4. If the Status screen displays, follow the instructions below.
"Busy"
Terminal ---
This screen displays if a condition, which might prevent accurate reporting,
exists on your system. If a number is listed next to "ERR" message, press
CASH to escape from this menu. Go to the workstation listed beside the ERR
message. Make sure all cables are securely connected, and the workstation is
operable. Go back to the System Master and repeat Steps 1 and 2.
If the above screen displays again, select one of the options explained next.
4-64
CASH 1
*** TERMINAL STATUS ***
BEGN #01 - END #04
ERR: #01
RETRY: 1 CASH
CONTINUE: 2 CASH
ESCAPE: CASH
0 0
Panasonic 5000 Version 3.0 Operating Instructions - Rev. 2.0
Reports
CASH