Port Access Vlan - HP 12500 Series Command Reference Manual

Views
VLAN view
Predefined user roles
network-admin
mdc-admin
Parameters
interface-list: Specifies an interface list, in the format of interface-list = { interface-type
interface-number [ to interface-type interface-number ] }&<1-10>, where interface-type
interface-number represents the interface type and interface number, and &<1-10> indicates that
you can specify up to 10 interface-type interface-number [ to interface-type interface-number ]
parameters.
Usage guidelines
This command is applicable only on access ports.
By default, all ports are access ports. However, you can manually configure the port type. For more
information, see
Examples
# Assign GigabitEthernet 3/0/1 through GigabitEthernet 3/0/3 to VLAN 2.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] port GigabitEthernet 3/0/1 to GigabitEthernet 3/0/3
Related commands
display vlan

port access vlan

Use port access vlan to assign the access ports to the specified VLAN.
Use undo port access vlan to restore the default.
Syntax
port access vlan vlan-id
undo port access vlan
Default
All access ports belong to VLAN 1.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Predefined user roles
network-admin
mdc-admin
Parameters
vlan-id: Specifies a VLAN ID in the range of 1 to 4094. Make sure the VLAN specified by the VLAN
ID already exists.
"port link-type."
107