Ethernet Link Aggregation Commands; Default; Description - HP 12500 Series Command Reference Manual

Ethernet link aggregation commands

The device does not support Layer 3 Ethernet interfaces/subinterfaces or Layer 3 aggregate
interfaces/subinterfaces when the system is operating in standard mode. For information about
commands for system operating modes, see Fundamentals Command Reference.
When the device operating in IRF mode is enabled with enhanced IRF mode, it does not support
creating Layer 3 Ethernet interfaces/subinterfaces or Layer 3 aggregate interfaces/subinterfaces. For
more information about enhanced IRF mode, see Fundamentals Configuration Guide.

default

Use default to restore the default settings for an aggregate interface.
Syntax
default
Views
Layer 2 aggregate interface view, Layer 3 aggregate interface view, Layer 3 aggregate subinterface
view
Predefined user roles
network-admin
mdc-admin
Usage guidelines
CAUTION:
The default command might interrupt ongoing network services. Make sure you are fully
aware of the impacts of this command when you execute it on a live network.
This command might fail to restore the default settings for some commands for reasons such as
command dependencies and system restrictions. Use the display this command in interface view to
identify these commands, and then use their undo forms or follow the command reference to
individually restore their default settings. If your restoration attempt still fails, follow the error
message instructions to resolve the problem.
Examples
# Restore the default settings for Layer 2 aggregate interface 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] default

description

Use description to configure a description for an interface.
Use undo description to restore the default setting.
13