Link-Aggregation Selected-Port Minimum; Mtu - HP 12500 Series Command Reference Manual

<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation selected-port maximum 5
Related commands

link-aggregation selected-port minimum

link-aggregation selected-port minimum
Use link-aggregation selected-port minimum to configure the minimum number of Selected ports
in the aggregation group.
Use undo link-aggregation selected-port minimum to restore the default setting.
Syntax
link-aggregation selected-port minimum number
undo link-aggregation selected-port minimum
Default
The minimum number of Selected ports in an aggregation group is not specified.
Views
Layer 2 aggregate interface view, Layer 3 aggregate interface view
Predefined user roles
network-admin
mdc-admin
Parameters
number: Specifies the minimum number of Selected ports in an aggregation group required to
bring up the aggregate interface, in the range of 1 to 48.
Usage guidelines
Executing this command may cause all member ports in the aggregation group to become
unselected.
The minimum number of Selected ports allowed in the aggregation groups of the local and peer
ends must be consistent.
Examples
# Configure the minimum number of Selected ports as 3 in the aggregation group that
corresponds to Layer 2 aggregate interface Bridge-Aggregation 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation selected-port minimum 3
Related commands
link-aggregation selected-port maximum

mtu

Use mtu to set the MTU of a Layer 3 aggregate interface or subinterface.
33