Revision-Level - HP 12500 Series Command Reference Manual

interface-number ] }&<1-10>, where &<1-10> indicates that you can specify up to 10 ports or port
ranges. If you don't specify this option, this command clears the spanning tree-related statistics
information on all ports.
Examples
# Clear the spanning tree-related statistics on ports GigabitEthernet 3/0/1 and GigabitEthernet
3/0/3.
<Sysname> reset stp interface GigabitEthernet 3/0/1 to GigabitEthernet 3/0/3
Related commands
display stp

revision-level

Use revision-level to configure the MSTP revision level.
Use undo revision-level to restore the default MSTP revision level.
Syntax
revision-level level
undo revision-level
Default
The MSTP revision level is 0.
Views
MST region view
Predefined user roles
network-admin
mdc-admin
Parameters
level: Specifies an MSTP revision level in the range of 0 to 65535.
Usage guidelines
The MSTP revision level, the MST region name, and the VLAN-to-instance mapping table of a
device determine the device's MST region. When the MST region name and VLAN-to-instance
mapping table are both the same for two MST regions, they can still be differentiated by their
MSTP revision levels.
After configuring this command, run the active region-configuration command to activate the
configured MST region level.
Examples
# Set the MSTP revision level of the MST region to 5.
<Sysname> system-view
[Sysname] stp region-configuration
[Sysname-mst-region] revision-level 5
Related commands
active region-configuration
•
60