Stp Port-Log - HP 12500 Series Command Reference Manual

Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Predefined user roles
network-admin
mdc-admin
Parameters
instance instance-list: Sets the priority of the ports in the MSTIs that are specified by an instance list,
in the format of instance-list = { instance-id [ to instance-id ] }&<1-10>, where &<1-10> indicates
that you can specify up to 10 instances or instance ranges. The instance-id argument is in the range
of 0 to 4094, and the value 0 represents the CIST.
priority: Specifies the port priority in the range of 0 to 240 in increments of 16 (as in 0, 16, 32).
Usage guidelines
The smaller the value, the higher the port priority. If all ports on your device use the same priority
value, the port priority depends on the port index. The smaller the index, the higher the priority.
When the setting is configured in Layer 2 Ethernet interface view, it takes effect on only that
interface.
When the setting is configured in Layer 2 aggregate interface view, it takes effect on only the
aggregate interface.
When the setting is configured on a member port in an aggregation group, it takes effect only after
the port leaves the aggregation group.
Examples
# In MSTP mode, set the priority of port GigabitEthernet 3/0/3 to 16 in MSTI 2.
<Sysname> system-view
[Sysname] interface GigabitEthernet 3/0/3
[Sysname-GigabitEthernet3/0/3] stp instance 2 port priority 16
Related commands
display stp

stp port-log

Use stp port-log to enable outputting port state transition information for the specified MSTI or for
all MSTIs.
Use undo stp port-log to disable outputting port state transition information for the specified
MSTI or for all MSTIs.
Syntax
stp port-log { all | instance instance-list }
undo stp port-log { all | instance instance-list }
Default
This function is disabled.
Views
System view
76