Port Trunk Pvid - HP 12500 Series Command Reference Manual

The configuration made in Layer 2 aggregate interface view applies to the aggregate interface
•
and its aggregation member ports.
If the system fails to apply the configuration to the aggregate interface, it stops applying
the configuration to aggregation member ports.
If the system fails to apply the configuration to an aggregation member port, it skips the
port and moves to the next member port.
Examples
# Assign the trunk port GigabitEthernet 3/0/1 to VLAN 2, VLAN 4, and VLAN 50 through VLAN 100.
<Sysname> system-view
[Sysname] interface GigabitEthernet 3/0/1
[Sysname-GigabitEthernet3/0/1] port link-type trunk
[Sysname-GigabitEthernet3/0/1] port trunk permit vlan 2 4 50 to 100
Related commands
port link-type

port trunk pvid

Use port trunk pvid to configure the PVID for the trunk port.
Use undo port trunk pvid to restore the default.
Syntax
port trunk pvid vlan vlan-id
undo port trunk pvid
Default
The PVID of a trunk port is VLAN 1.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Predefined user roles
network-admin
mdc-admin
Parameters
vlan-id: Specifies a VLAN ID in the range of 1 to 4094.
Usage guidelines
You can use a nonexistent VLAN as the PVID for a trunk port. If you remove the PVID of a trunk
port with the undo vlan command, the setting of the PVID on the port is not affected.
The local and remote trunk ports must use the same PVID for the packets of the PVID to be
transmitted correctly.
You must configure the trunk port to allow and forward packets from the PVID by using the port
trunk permit vlan command.
The configuration made in Layer 2 Ethernet interface view applies only to the port.
•
The configuration made in Layer 2 aggregate interface view applies to the aggregate interface
•
and its aggregation member ports.
112