Port Hybrid Pvid - HP 12500 Series Command Reference Manual

Usage guidelines
Before assigning an access port to VLAN, make sure the VLAN has been created.
The configuration made in Layer 2 Ethernet interface view applies only to the port.
•
The configuration made in Layer 2 aggregate interface view applies to the aggregate interface
•
and its aggregation member ports.
If the system fails to apply the configuration to the aggregate interface, it stops applying
the configuration to aggregation member ports.
If the system fails to apply the configuration to an aggregation member port, it skips the
port and moves to the next member port.
Examples
# Assign GigabitEthernet 3/0/1 to VLAN 3.
<Sysname> system-view
[Sysname] vlan 3
[Sysname-vlan3] quit
[Sysname] interface GigabitEthernet 3/0/1
[Sysname-GigabitEthernet3/0/1] port access vlan 3

port hybrid pvid

Use port hybrid pvid to configure the PVID of the hybrid port.
Use undo port hybrid pvid to restore the default.
Syntax
port hybrid pvid vlan vlan-id
undo port hybrid pvid
Default
The PVID of a hybrid port is VLAN 1.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Predefined user roles
network-admin
mdc-admin
Parameters
vlan-id: Specifies a VLAN ID in the range of 1 to 4094.
Usage guidelines
You can use a nonexistent VLAN as the PVID for a hybrid port. If you remove the PVID of a hybrid
port with the undo vlan command, the setting of the PVID on the port is not affected.
HP recommends that you set the same PVID for the local and remote hybrid ports.
You must configure the hybrid port to allow and forward packets from the PVID by using the port
hybrid vlan command.
The configuration made in Layer 2 Ethernet interface view applies only to the port.
•
108