Configuring The Loitering Detection Function - Huawei IPC6125-WDL-FA Configuration Manual

IPC6125-WDL-FA
Configuration Guide
Step 6 Click Save.
The intrusion detection function is configured.
----End
Verification
When an individual enters the sensitive area:
l
l

9.2 Configuring the Loitering Detection Function

The loitering detection function checks whether an object loiters in a sensitive area for a time
period longer than a specified duration. The system generates an alarm when a loitering object
is detected.
Prerequisites
Predefined sensitive areas for behavior analysis can be displayed on live video images only
when Video stream type is set to Hybrid stream. To set Video stream type, choose Settings
> System Configuration > Local Parameters.
Issue 01 (2016-08-20)
If the individual is marked with a red box and the individual's movement track is
displayed as a red line on the live video image, intrusion detection is successfully
configured.
If the individual is not marked on the live video image, intrusion detection is not
properly configured or not enabled.
solutions.
Table 9-4 Possible causes
Cause
The surveillance area is too large.
The surveillance area is too small.
In the Global configuration area, verify
that Enable is selected.
The sensitive area is not in Enable state
when Behavior type is set to Intrusion
detection on the Behavior Analysis
Parameters page.
Video alarm deployment is not Enable
on the Alarm Deployment Policy page
that is displayed when you choose
Settings > Alarm Configuration >
Alarm Deployment Policy.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 Setting Intelligent Analysis Parameters
Table 9-4 lists the possible causes and their
Solution
Adjust the focal length and dimensions of
the surveillance area to ensure that the
intended object can be detected.
Select Enable.
Select the sensitive area ID from the
sensitive area list and click Enable to
enable the sensitive area.
Select Enable.
108