Setting Multicast Parameters; Setting Ip Filter Parameters - Huawei IPC6125-WDL-FA Configuration Manual

IPC6125-WDL-FA
Configuration Guide

7.1.4 Setting Multicast Parameters

In multicast transmission mode, a sender sets up P2MP network connections with all
receivers, improving data transmission efficiency and lowering the possibility of backbone
network congestion.
Procedure
Step 1 Choose Settings > Network Configuration > Network Parameters.
The page for Network Parameters is displayed.
Step 2 Set multicast parameters. For detailed parameter description, see
Figure 7-4 Multicast parameters
Table 7-1 Parameter description
Parameter
Multicast IP
Port number
----End

7.2 Setting IP Filter Parameters

You can use the IP filter function to allow or deny the access of IP data packets coming from
a specified IP network segment, port, or using a specified protocol, to the IPC.
Context
l
l
Issue 01 (2016-08-20)
Description
Multicast IP address of media streams.
NOTE
Multicast port number of media streams.
NOTE
An IP address segment is obtained by performing a logical-AND of the IP address and
subnet mask.
A maximum of three IP filter rules can be added.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Value range: 224.0.0.0 to 239.255.255.255
The default value is 1234.
7 Setting Network Parameters
Table 7-1.
76