Setting Motion Detection Parameters - Huawei IPC6125-WDL-FA Configuration Manual

IPC6125-WDL-FA
Configuration Guide
l Operations on a privacy mask area take effect only after they are saved. You can perform operations on
l You can draw a maximum of eight quadrilateral privacy mask areas. You can set the color for these areas.
l You can draw a maximum of two square mosaics areas. You cannot set the color for these areas.
Step 4 Use the mouse to adjust the location of the privacy mask area.
Step 5 Click Save.
Step 6 Go to the Preview page and check whether the location and size of the privacy mask area
meet the requirements.
l
l
You can delete unnecessary privacy mask areas. In the No. area, select the ID of the privacy mask area to
delete, and click Delete.
----End

6.10 Setting Motion Detection Parameters

An alarm is generated when an object moves within the specified surveillance range of the
camera.
Procedure
Step 1 Choose Settings > Channel Configuration > Motion Detection Parameters.
The page for setting motion detection parameters is displayed, as shown in
Figure 6-13 Motion detection Parameters tab page
Step 2 To enable motion detection, select Enable.
Step 3 Click Add.
A motion detection area is displayed on the live video image.
Issue 01 (2016-08-20)
NOTE
only one privacy mask are at a time.
The default color is black.
If yes, the configuration is complete.
If no, configure the privacy mask area again.
NOTE
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 Setting Video Parameters
Figure 6-13.
68