Configuring The Video Block Detection Function - Huawei IPC6125-WDL-FA Configuration Manual

IPC6125-WDL-FA
Configuration Guide
Step 6 Click Save.
The tripwire detection function is configured.
----End
Verification
When an individual crosses the tripwire in the specified direction:
l
l

9.6 Configuring the Video Block Detection Function

You can configure video block detection function for the full screen. After the configuration,
an alarm will be generated when the camera lens is blocked.
Procedure
Step 1 Choose Settings > Intelligent Analysis > Video Block Detection.
The Video Block Detection page is displayed, as shown in
Issue 01 (2016-08-20)
If the individual is marked with a red box and the individual's movement track is
displayed as a red line on the live video image, tripwire detection is successfully
configured.
If the individual is not marked on the live video image, tripwire detection is not properly
configured or not enabled.
Table 9-20 Possible causes
Cause
The surveillance area is too large.
The surveillance area is too small.
In the Global configuration area, verify
that Enable is selected.
The sensitive area is not in Enable state
when Behavior type is set to If the
individual is not marked on the live
video image, tripwire detection is not
properly configured or not enabled. on
the Behavior Analysis Parameters page.
Video alarm deployment is not Enable
on the Alarm Deployment Policy page
that is displayed when you choose
Settings > Alarm Configuration >
Alarm Deployment Policy.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Table 9-20 lists the possible causes and their solutions.
Solution
Adjust the focal length and dimensions of
the surveillance area to ensure that the
intended object can be detected.
Select Enable.
Select the sensitive area ID from the
sensitive area list and click Enable to
enable the sensitive area.
Select Enable.
9 Setting Intelligent Analysis Parameters
Figure 9-11.
136