Table of Contents
Advertisement
PTP 250 User Guide
Connecting an RJ45 and gland to a unit
Perform this task to connect the drop cable to an ODU or LPU. This procedure
contains illustrations of an ODU, but it applies in principle to both the ODU and the
LPU.
To connect the drop cable with a gland to a unit (LPU or ODU), proceed as follows:
1
Insert the RJ45 plug into the socket in the unit, making sure that the
locking tab snaps home.
2
Support the drop cable and gently hand screw the gland body into the
unit until the O ring seal is flush to the unit body.
Once the gland is fully hand screwed into the unit, tighten it with a
3
spanner to torque 10 Nm (7.4 ftlbs).
phn-2182_002v000
May 2011
NOTE
Do not fit the back shell prior to securing the gland body.
Installing the drop cable and LPU
5-19
Advertisement
Table of Contents
