Preparing The Poe Power Supply To Network Equipment Cable - Motorola PTP 250 User Manual

Installing the PoE power supply

Preparing the PoE power supply to network equipment cable

Prepare the CAT5e cable that will connect the PoE power supply to the network
equipment. This cable must meet the following requirements:
x
Use either foil screen (FTP) or braided screen (STP) cable.
x
Use screened RJ45 connectors with metal shells at both ends.
x
Ensure there is a continuous electrical connection between both screened
connectors.
CAUTION
The PoE power supply is not normally connected to the network equipment until
antenna alignment is complete. See
5-30
The connected network equipment must feature screened RJ45
connectors and must be connected to ground, otherwise the PoE power
supply will not be grounded.
Connecting to the network
Chapter 5 Installation
on page 6-35.
phn-2182_002v000
May 2011