Preparing For Configuration And Alignment; Safety Precautions During Configuration And Alignment; Regulatory Compliance During Configuration And Alignment; Selecting Configuration Options - Motorola PTP 250 User Manual

Preparing for configuration and alignment

Preparing for configuration and alignment
This section describes the checks to be performed before proceeding with unit
configuration and antenna alignment.

Safety precautions during configuration and alignment

All national and local safety standards must be followed while configuring the units
and aligning the antennas.
WARNING
o
o

Regulatory compliance during configuration and alignment

All applicable radio regulations must be followed while configuring the units and
aligning the antennas. For more information, refer to
regulations

Selecting configuration options

Use the installation report to determine which configuration options are required.
Refer to PTP LINKPlanner
6-2
Ensure that personnel are not exposed to unsafe levels of RF energy.
The units start to radiate as soon as they are powered up. Respect the
safety standards defined in
page 4-22, in particular the minimum separation distances. Observe
the following guidelines:
Never work in front of the antenna when the ODU is powered.
Always power down the PoE power supply (or PIDU) before connecting or
disconnecting the drop cable from either the power supply, ODU or LPU.
on page 4-27.
on page 2-8.
Chapter 6 Configuration and alignment
Compliance with safety standards
Compliance with radio
on
phn-2182_002v000
May 2011