Table of Contents
Advertisement
Restoring, resetting and rebooting
Resetting to default configuration (with country reset)
Use the reset plug (supplied in each PTP 250 'Link Complete' or 'End Complete' kit) to
reset the unit to factory default configuration, including reset of the country of
operation (this will have to be reselected at first login after the reset).
CAUTION
NOTE
To reset to default configuration including country reset, proceed as follows:
1
Remove the ODU drop cable from the PoE power supply DATA & POWER
OUT port.
2
Plug the ODU drop cable into the reset plug and then plug the reset plug
into the PoE power supply DATA & POWER OUT port
3
Wait for at least 45 seconds.
4
Disconnect the reset plug and re-insert the ODU drop cable into the PoE
power supply DATA & POWER OUT port.
5
The unit should now be reset to factory default settings, including the
following:
6
To reconfigure the unit, follow the instructions in
on page
7-26
When the unit is reset to default configuration, the current configuration is
lost and the unit reboots, causing loss of service.
To reset the unit to factory defaults without resetting the country of
operation, follow the procedure in
(without country reset)
Password 'motorola',
IP address '169.254.1.1',
Master Slave Status 'Slave',
Country Code is blank.
6-3
and
Using the installation wizard
NOTE
When logging into the unit, change Password and select Country
Code (these will be prompted).
Resetting to default configuration
on page 7-25.
Chapter 7 Operation
(Figure
7-13).
Connecting to the unit
on page 6-14.
phn-2182_002v000
May 2011
Advertisement
Table of Contents
