Table of Contents
Advertisement
Overview of the PTP 250
System components
Each end of the link consists of:
x
Outdoor Unit (ODU): An integrated (or connectorized) outdoor transceiver unit
containing all the radio and networking electronics.
x
PoE power supply: An indoor connection box containing a mains power supply,
status indicators and network connection port.
x
Cabling and lightning protection: CAT5e cables, grounding cables, connectors
and a lightning protection unit (LPU).
Product variants
The PTP 250 is available in the following product variants:
x
FCC/IC or ETSI/RoW: The PTP 250 is available in two regional variants: one is
for use in countries where FCC or IC licensing restrictions apply (FCC/IC), and
the other is for use in ETSI countries or the rest of the world (ETSI/RoW). The
regional variants may operate in the following bands:
o
o
x
Integrated or Connectorized: Both products are available in either Integrated
(with attached antenna) or Connectorized (without an antenna) variants.
x
Link Complete or End Complete: The Link Complete kit consists of two ODUs
and two PoE power supply units. The End Complete kit consists of one ODU and
one PoE power supply unit.
To obtain part numbers for the above variants, refer to
4-2.
NOTE
1-4
ETSI/RoW: 5.4 GHz or 5.8 GHz.
FCC/IC: 5.8 GHz only.
The PTP 250 is not currently approved for 5.4 GHz operation in the USA or
Canada.
Chapter 1 Product description
Installation inventories
phn-2182_002v000
May 2011
on page
Advertisement
Table of Contents
