Table of Contents
Advertisement
System management
Firmware upgrade
The management agent supports application firmware upgrade using the web-based
interface.
PTP 250 firmware images are digitally signed, and the ODU will accept only images
that contain a valid Motorola PTP digital signature. The ODU always requires a reboot
to complete a firmware upgrade.
Obtain the application firmware and this user guide from the support website
(http://www.motorola.com/ptp/support) BEFORE warranty expires.
CAUTION
The procedure for firmware upgrade is described in
page 6-10.
Reset to factory defaults
The 'reset to factory defaults' feature provides a means to recover from serious
configuration errors, such as lost or forgotten passwords.
Use the reset plug (supplied in each PTP 250 'Link Complete' or 'End Complete' kit) to
reset the unit to factory default configuration, including reset of the country that was
selected at first login. Following the procedure in
(with country reset)
Use the Save & Restore page to reset the unit to factory default configuration, without
resetting the country that was selected at first login. Follow the procedure in
to default configuration (without country reset)
Further reading on system management
For more information on system management, refer to the following:
x
Chapter 6 Configuration and alignment
tasks that are performed when a PTP 250 link is deployed.
x
Chapter 7 Operation
interface.
1-28
ODU firmware version must be the same at both ends of the link. Limited
operation may sometimes be possible with dissimilar firmware versions, but
such operation is not supported by Motorola.
on page
7-26
provides instructions for operators of the PTP 250 web user
Chapter 1 Product description
Upgrading firmware version
Resetting to default configuration
on page 7-25.
describes all configuration and alignment
phn-2182_002v000
on
Resetting
May 2011
Advertisement
Table of Contents
