Table of Contents
Advertisement
PTP 250 User Guide
Resetting to default configuration (without country reset)
Use the Save & Restore page to reset the unit to factory default configuration, without
resetting the country of operation (selected at first login).
CAUTION
NOTE
To reset to default configuration without country reset, proceed as follows:
Select menu option Configuration, Save And Restore. The Save &
1
Restore page is displayed
Select Reset to Default Configuration and Yes to confirm.
2
Wait for at least 45 seconds.
3
4
The unit should now be reset to partial factory default settings, including
the following:
The Country Code (selected at first login) remains unchanged.
To reconfigure the unit, follow the instructions in
5
on page
phn-2182_002v000
May 2011
When the unit is reset to default configuration, the current configuration is
lost and the unit reboots, causing loss of service.
To reset the unit to factory default configuration, including reset of the
country that was selected at first login, follow the procedure in
default configuration (with country reset)
Password 'motorola',
IP address '169.254.1.1',
Master Slave Status 'Slave'.
6-3
and
Using the installation wizard
NOTE
When logging into the unit, change Password (this will be prompted).
on page 7-26.
(Figure
6-11).
Restoring, resetting and rebooting
Resetting to
Connecting to the unit
on page 6-14.
7-25
Advertisement
Table of Contents
