Programming technology functions (cycles)
8.4 Milling
Note
The following error messages can occur when chamfering inside contours:
• Safety clearance in the program header too large
• Immersion depth too large
• Tool diameter too large
Additional supplementary conditions
● Finishing
● Edge finishing
● Chamfering
Procedure
420
This error message appears when chamfering would, in principle, be possible with the
parameters entered for FS and ZFS, but the safety clearance then could not be
maintained.
This error message appears when chamfering would be possible through the reduction of
the immersion depth ZFS.
This error message appears when the tool would already damage the edges during
insertion. In this case, the chamfer FS must be reduced.
1/2 slot width W ≤ milling cutter diameter
Finishing allowance UXY ≤ milling cutter diameter
The tip angle must be entered into the tool table.
1.
The part program or ShopTurn program to be processed has been
created and you are in the editor.
2.
Press the "Milling" softkey.
3.
Press the "Slot" and "Open slot" softkeys.
The "Open slot" input window opens.
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
Turning