Siemens SINUMERIK 840D sl Operating Manual page 44

Introduction
1.4 User interface
Tool data
Display
T
Tool name
Location
D
H
Ø
R
Z
X
Feed data
Display
F
Rapid traverse
0.000
Override
44
Meaning
Name of the current tool
Location number of the current tool
Cutting edge of the current tool
The tool is displayed with the associated tool type symbol corresponding to
the actual coordinate system in the selected cutting edge position.
If the tool is swiveled, then this is taken into account in the display of the
cutting edge position.
In DIN-ISO mode the H number is displayed instead of the cutting edge
number.
H number (tool offset data record for DIN-ISO mode)
If there is a valid D number, this is also displayed.
Diameter of the current tool
Radius of the current tool
Z value of the current tool
X value of the current tool
Meaning
Feed disable
Actual feed value
If several axes traverse, is displayed for:
"JOG" mode: Axis feed for the traversing axis
•
"MDA" and "AUTO" mode: Programmed axis feed
•
G0 is active
No feed is active
Display as a percentage
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
Turning