Position Pattern Line (Holes1), Grid Or Frame (Cycle801) - Siemens SINUMERIK 840D sl Operating Manual

8.1.11

Position pattern line (HOLES1), grid or frame (CYCLE801)

Function
You can program the following pattern using the "Position pattern" cycle:
● Line (HOLES1)
● Grid (CYCLE801)
● Frame (CYCLE801)
Procedure
Parameter Description
LAB Repeat jump label for position
(only for G code)
PL Machining plane
(only for G code)
Machining
Face C
•
surface
Face Y
•
Peripheral surface C
•
(only for
ShopTurn)
Peripheral surface Y
•
Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
In the "Line" selection option you can program any number of positions at equal distances
along a line.
You can use the "Grid" selection option to program any number of positions spaced at an
equal distance along one or several parallel lines.
If you want to program a rhombus-shaped grid, enter angle αX or αY.
You can use the "Frame" selection option to program any number of positions spaced at
an equal distance on a frame. The spacing may be different on both axes.
If you want to program a rhombus-shaped frame, enter angle αX or αY.
1. The part program or ShopTurn program to be processed has been
created and you are in the editor.
2. Press the "Drilling" softkey.
3. Press the "Positions" and "Line" softkeys.
The "Position Pattern" input window opens.
Programming technology functions (cycles)
8.1 Drilling
Unit
307