Tool management
11.16 Working with multitool (only 840D sl)
11.16.9
Positioning multitool
You can position a magazine. In this case, a magazine location is positioned to the loading
point.
Multitools, which are located in a spindle, can also be positioned. The multitool is rotated and
therefore the multitool location involved is brought into the machining position.
Procedure
634
Enter the required magazine number in the "...magazine" field
and the required magazine location number in "Location" field.
Press the "OK" softkey.
The multitool with the tools is relocated to the specified magazine
location.
1.
The magazine list is opened.
2.
Position the cursor at the multitool location, which you wish to
bring into the machining position (the multitool is located in the
spindle).
3.
Press the "Position multitool" softkey.
If the cursor is at a multitool location of a multitool, which is
located in the spindle, the multitool location is positioned to the
machining position.
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
Turning