Commissioning NC-controlled drives
6.6 Diagnostics → Trace
6.6.5
Example: Positioning the cursor
Positioning the cursor
Procedure:
1. Select the "Cursors >" softkey and position the active cursor A at the required position.
2. Select the "Cursor B >" softkey and position the active cursor B at the required position.
3. Select the "Both Cursors" softkey in order to read the precise value of the cursor positions
below the graphic:
6.6.6
Example: Trace session with PLC variables
Trace recording of PLC signals
Procedure:
1. Using softkey "New trace (Drive/NC)", open a new session.
2. Select the "Choose variable >" softkey, and under "Filter: PLC" to restrict the selection to
PLC variables.
172
CNC Commissioning: NC, PLC, Drive
Commissioning Manual, 12/2019, A5E48312804B AA