Siemens SINUMERIK 840D sl Commissioning Manual page 92

PLC commissioning
5.5 Download the project to the PLC
Operating sequence for loading system blocks into the module
1. To load the configuration of the system blocks change to the SIMATIC Manager.
2. In the SIMATIC Manager in the PLC directory, select the directory "Blocks" > right mouse
button > "Target system" > "Load" (see figure below), or the "Load" symbol.
Figure 5-4
3. If there is no connection to the target system, you must confirm in sequence the following
dialog requests with:
– "OK" for "Check the required sequence of blocks for correct functioning"
– "Yes" for "Do you want to load system data?"
– "Yes" for "Must system data be deleted on the module and replaced by off-line system
– "No" for "The module is in STOP mode. Do you want to start the module (cold restart)?"
You have loaded the PLC program to the PLC; the PLC is in "STOP" mode.
Note
If the PLC is stopped via the SIMATIC Manager, then it also has to be started via the
SIMATIC Manager. Starting via the PLC mode selector is also possible.
92
Loading system blocks
data?"
CNC Commissioning: NC, PLC, Drive
Commissioning Manual, 12/2019, A5E48312804B AA