Assigning Interfaces - Siemens SINUMERIK 840D sl Commissioning Manual

5.8.3

Assigning interfaces

Introduction
The interfaces configured in the previous chapter must now be assigned in a device-specific
manner to the available hardware interfaces on the PG/PC.
Operating sequence for assigning an Ethernet interface
1. Select the "Assign" tab.
2. Select "Ethernet interface(1)" in the selection field "Configured interfaces".
3. Select in the "Interface parameter assignments in the PG/PC" selection field, the "TCP/IP -
> Realtek RTL8139/810xF..." network card installed on the PG/PC.
4. To transfer the interfaces from the "Not assigned" area to the "Assigned" area and activate
them, click "Assign" and confirm the subsequent prompt on editing the object properties with
"OK".
CNC Commissioning: NC, PLC, Drive
Commissioning Manual, 12/2019, A5E48312804B AA
5.8 Configuring a network (NetPro) for PG/PC
PLC commissioning
99