6.5.2
Adding a data set
NC/PLC interface
The factory setting is a motor data set MDS0 with a drive data set DDS0. This logic is provided
in the data set wizard in SINUMERIK Operate and corresponds with the first line:
NC/PLC interface
DB31, ... DBX21.0 - 4
DB31, ... DBX93.0 - 4
DB31, ... DBX130.0 - 4
Blue
Yel‐
low
Gray Invalid bit position
CNC Commissioning: NC, PLC, Drive
Commissioning Manual, 12/2019, A5E48312804B AA
Motor data set (MDS)
Drive data set (DDS)
Commissioning NC-controlled drives
MDS/DDS
PLC → NC
Selection
NC → PLC
Display
NC → PLC
Formatting
6.5 Configuring data sets
155