Siemens SINUMERIK 840D sl Commissioning Manual page 27

Reinstallation of the CNC software
Procedure
①
Install the CNC software on the CompactFlash card using
one of the following media:
● Bootable USB FlashDrive
● WinSCP on PC/PG
● VNC viewer on PC/PG
②
Powering up the control system with NC/PLC general reset → NC/PLC general reset (Page 34)
③
Establish a communication connection to the PLC
④
Commission the PLC
⑤
Commission the SINAMICS drive system
⑥
NC ↔ drive communication
⑦
Commission the NC:
● Assign the NC machine data for the communication
● Scale the machine data
● Parameterize the axis data
● Parameterize the spindle data
● Parameterize the measuring systems
⑧
Drive tuning
Upgrading the CNC software
Procedure
①
Archive the NC, PLC, HMI and drive data
②
Upgrade CNC software using:
● Access MyMachine /P2P
● WinSCP and VNC Viewer
③
Load the archived NC, PLC, HMI and drive data
CNC Commissioning: NC, PLC, Drive
Commissioning Manual, 12/2019, A5E48312804B AA
2.4 Procedure for the initial commissioning
Reference to Chapter
→ New installation / upgrade (Page 355)
→ Establishing a communication connection (Page 51)
→ PLC commissioning (Page 51)
→ Commissioning NC-controlled drives (Page 103)
→ Communication between the NC and the drive
(Page 215)
→ NC commissioning (Page 231)
→ Procedure when commissioning the NC (Page 233)
→ Drive tuning (Page 291)
Reference to Chapter
→ Save data (Page 345)
→ New installation / upgrade (Page 355)
→ Load data (Page 345)
Introduction
27