New Installation / Upgrading; With The Help Of An Ncu Service System; New Installation - Siemens SINUMERIK 840D sl Commissioning Manual

New installation / upgrading

12.1

With the help of an NCU service system

Introduction
The CNC software on the CompactFlash card can be newly installed or upgraded.
● A reinstallation is required if there is no CNC software on the CompactFlash card (see
Section New installation (Page 355)).
● An upgrade is required if an older CNC software is available on the CompactFlash card (see
Chapter Upgrading (Page 362))
Tools for reinstallation/upgrade
You can perform a reinstallation/upgrade using the following tools:
● Access MyMachine /P2P
● WinSCP and VNC Viewer
For a reinstallation/upgrade, you require a bootable USB FlashDrive as an NCU service
system.
Additional information is provided in Chapter "Generate service system" in the Operating
system NCU (IM7) (https://support.industry.siemens.com/cs/de/de/view/109481527/en)
Commissioning Manual
12.1.1

New installation

Introduction
No CNC software was installed on the CompactFlash Card. The CompactFlash Card is empty.
You have the following options of initiating a new installation of the CNC software:
● Automatic installation using USB-FlashDrive
● Installation using USB-FlashDrive
● Installation using WinSCP on PG/PC
● Installation using VNC Viewer on PG/PC
CNC Commissioning: NC, PLC, Drive
Commissioning Manual, 12/2019, A5E48312804B AA
12
355