Siemens SINUMERIK 840D sl Commissioning Manual page 375

8. Create a package "<name>.usz" via the menu "File" > "Transfer" > "Linux package (NCU)
and select as target path the root directory of the USB FlashDrive.
Create MyConfig Expert saves the project, performs a validation run, creates and saves the
package under the specified target path.
A "<name>.usz" package is then located in the root directory of the USB FlashDrive.
Depending on the configuration in the previous step, the "<name>.tgz" file is also located
next to the package.
Note
The USB FlashDrive must only be bootable if the CompactFlash card of the NCU does not
contain executable CNC system software.
9. Insert the USB FlashDrive into a USB socket (X125 or X135) of the NCU.
10.Switch the control system off and on again.
Provided that when configuring you configured the "Edit mode of all dialogs" > "Automatic",
then the package is automatically executed when the control system boots-up. The dialogs
are displayed, but require no operator actions.
The CNC software has been installed once the package has been completed.
A logbook about the activities that have been performed can be saved. The logbook
documents all activities performed during the new installation.
11.Switch-off the control system.
12.Remove the USB FlashDrive.
13.Commissioning work can continue after the control system has been switched on.
Optional additional functions for the installation of the CNC software
In the same package - after the CNC software has been installed - the following actions can be
optionally configured, which can either run completely automatically or conditionally at the
machine:
● Loading an SDB Archive
● SINAMICS device configuration
● Renaming DO, SINAMICS components and DO numbers
● Assignment of the drives to NC axes
● Manipulation of display machine data
● Manipulation of individual NC and drive data
● Loading the PLC program or from individual blocks
● Installing software
● Copying, deleting and manipulating files on the CompactFlash card
● Conditional execution of actions, executing, deleting, copying and manipulating
● Messages and interactions to the operator
CNC Commissioning: NC, PLC, Drive
Commissioning Manual, 12/2019, A5E48312804B AA
12.2 With the help of the "Create MyConfig" software
New installation / upgrading
375