Equipping Multitool With Tools - Siemens SINUMERIK 840D sl Operating Manual

11.16.3

Equipping multitool with tools

Requirement
A multitool has been created in the tool list.
Procedure
Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
1. The tool list is opened.
2. Select the required multitool, position the cursor at an empty
multitool location and press the "New tool" softkey.
Using the appropriate selection list, e.g. favorites, select the
required tool
- OR -
Position the cursor on the tool that you wish to load into the
multitool and press the "Load" and "Multitool" softkeys.
The "Load to..." window opens.
Select the required multitool and the multitool location to which
you wish to load the tool.
11.16 Working with multitool (only 840D sl)
Tool management
629