NEC Express5800 series User Manual page 179

After the insertion, push the riser card with your fingers until it is fully seated.
12.
13. Install the components you removed previously.
14. Verify that POST displays no error messages.
If POST displays an error message, take note of the message and see the POST error
messages listed in Chapter 6.
Select "Yes" for [Advanced] → [Reset Config Data].
15.
This setting is required to change the hardware configuration data. See Chapter 3 for
details.
Start the BIOS configuration utility in the installed card, and set up the card.
16.
Presence/absence of the utility and the start and operation methods depend on the card.
For details, see the manual provided with the card. If a PCI board (e.g., a disk array
controller, SCSI controller, or LAN card) with a bootable device connected is
additionally installed, the boot priority is changed to the default. After the additional
installation, start the BIOS setup utility, select [Boot] → [Boot Device Priority], and
set the new boot priority. (See Chapter 3.)
Removing a PCI Board
Remove a PCI board in reverse order of the installation steps. After the removal, start the BIOS
setup utility, select [Boot] → [Boot Device Priority], and set the new boot priority. (See
Chapter 3.)
Low-profile type Full-height type
Upgrading Your NEC Storage 169