NEC Express5800 series User Manual page 93

Console Redirection
Select "Console Redirection" on the Server menu and press Enter to display the following
screen.
See the table below for setup options on the screen.
Option Parameter
Serial Console [Disabled]
Redirection Enabled
Serial Port COM1 3F8 IRQ4
COM2 2F8 IRQ3
Baud Rate 9600
[19.2k]
38.4k
115.2k
Flow Control No Flow Control
[CTS/RTS]
XON/XOFF
CTS/RTS+CD
Description
Specifies whether BIOS uses the specified
serial port to redirect the console to MWA
or remote terminals using hyper terminal.
Disable the Quiet Boot option in BOOT
menu.
Selects an address/interrupt for the serial
port used for redirection.
Make sure to use the same
address/interrupt as specified in
[Advanced] - [Peripheral Configuration].
Selects a baud rate for communications
with the connected HW console.
[56k] is not available.
Select a flow control method.
Your Setting
[ ]: Factory-set
Setting Up Your Storage Server 83