Configuring Motherboard Jumpers - NEC Express5800 series User Manual

CONFIGURING MOTHERBOARD JUMPERS

With the pre-installed SETUP utility, you can set desired passwords to protect the data stored in
the server against access from unauthorized users. When you forget the passwords, however,
you may want clear them. The following describes how to clear these passwords. You can also
use the following procedure to clear the CMOS data in the server.
IMPORTANT:
configuration data. After clearing the CMOS contents, change the
setting as shown below. This setting is necessary for operating the
server correctly.
Select [Advanced] → [Peripheral Configuration] → [Legacy USB
Support] → [Disabled].
Select [Boot] → [Boot Device Priority] → [ATAPI CD-ROM
Drive] → [1st Boot Device].
Select [Boot] → [Boot Device Priority] → [Removable Drive] →
[2nd Boot Device].
Select [Boot] → [Hard Disk], and set the boot order.
To clear passwords or the CMOS data, use the jumper switch on the system board of the server.
The following figure illustrates the jumper switch location.
IMPORTANT:
may cause the server to fail or malfunction.
100 Setting Up Your Storage Server
Clearing the CMOS data resumes the factory-set
Do not change any other switch settings. Any change
Clears the password.
Clears the CMOS contents.
PSWD Clear: Pin for protecting/clearing the password
CMOS Clear: Pin for protecting/clearing the CMOS
contents (The figure shows the factory-set.)