Step
3.
Specify
address.
Specifying the MD source interface
The MTI uses the IP address of the MD source interface as the source address to encapsulate the VPN
multicast packets. The IP address of the MD source interface must be the same as the source address used
for establishing BGP peer relationship. Otherwise, correct routing information cannot be obtained.
Perform the following configuration on the PE.
To specify the MD source interface:
Step
1.
Enter system view.
2.
Enter MD view.
3.
Specify
interface.
Configuring MDT switchover parameters
In some cases, the traffic rate of the private network multicast data might fluctuate around the MDT
switchover threshold. To avoid frequent switching of multicast traffic between the default-MDT and the
data-MDT, you can specify a data-delay period and a data-holddown period.
•
MDT switchover does not take place immediately after the multicast traffic rate exceeds the
switchover threshold. It takes place after a data-delay period, during which the traffic rate must stay
higher than the switchover threshold.
Likewise, a backward switching does not take place immediately after the multicast traffic rate
•
drops below the MDT switchover threshold. It takes place after a data-holddown period, during
which the traffic rate must stay lower than the switchover threshold.
Perform the following configuration on the PE.
To configure MDT switchover parameters:
Step
1.
Enter system view.
Enter MD view.
2.
3.
Configure
address
switchover criteria.
4.
Configure
period.
Command
a
default-group
default-group group-address
Command
system-view
multicast-domain vpn-instance
vpn-instance-name
the
MD
source
source interface-type
interface-number
Command
system-view
multicast-domain vpn-instance
vpn-instance-name
data-group group-address
the
data-group
{ mask-length | mask } [ threshold
range
and
the
threshold-value | acl acl-number ]
*
the
data-delay
data-delay delay
186
Remarks
By default, no default-group
address is specified.
Remarks
N/A
N/A
By default, no IP address of the MD
source interface is specified.
Remarks
N/A
N/A
By default, no data-group address
range is configured and multicast
traffic never switches to a
data-MDT.
Optional.
The default setting is 3 seconds.