Configuring Ipv6 Multicast Source Port Filtering - HP MSR2003 Configuration Manual

Configuring an IPv6 multicast group filter on a port
Step
1. Enter system view.
2. Enter Layer 2 Ethernet interface
view.
3. Configure an IPv6 multicast
group filter for the port.

Configuring IPv6 multicast source port filtering

This feature is supported on the following hardware:
MSR routers installed with the Layer 2 switching module HMIM 24GSW, HMIM 24GSW-POE, or HMIM
8GSW.
When the IPv6 multicast source port filtering feature is enabled on a port, the port blocks all multicast
data packets, but it permits IPv6 multicast protocol packets to pass. You can connect the port to only IPv6
multicast receivers rather than to multicast sources.
If this feature is disabled on the port, you can connect the port to either multicast sources or IPv6 multicast
receivers.
You can enable multicast source port filtering either for the specified ports in MLD-snooping view or for
the current port in interface view. These configurations have the same priority level.
Configuring IPv6 multicast source port filtering globally
Step
1. Enter system view.
2. Enter MLD-snooping view.
3. Enable IPv6 multicast source
port filtering.
Configuring IPv6 multicast source port filtering on a port
Step
1. Enter system view.
2. Enter Layer 2 Ethernet interface
view.
3. Enable IPv6 multicast source
port filtering.
Command
system-view
interface interface-type
interface-number
mld-snooping group-policy
acl6-number [ vlan vlan-list ]
Command
system-view
mld-snooping
source-deny port interface-list
Command
system-view
interface interface-type
interface-number
mld-snooping source-deny
232
Remarks
N/A
N/A
By default, no IPv6 multicast group
filter is configured for the port. The
hosts on this port can join any valid
IPv6 multicast group.
Remarks
N/A
N/A
By default, the IPv6 multicast
source port filtering is disabled.
Remarks
N/A
N/A
By default, the IPv6 multicast
source port filtering is disabled.