Configuration Task List; Enabling Ipv6 Multicast Routing; Configuring Ipv6 Multicast Routing And Forwarding; Configuring The Rpf Route Selection Rule - HP MSR2003 Configuration Manual

As shown in
A encapsulates the IPv6 multicast data in unicast IPv6 packets, and forwards them to Router B across the
tunnel through unicast routers. Then, Router B strips off the unicast IPv6 header and continues to forward
the IPv6 multicast data down toward the receivers.

Configuration task list

Tasks at a glance
(Required.)
(Optional.)
•
(Optional.)
•
(Optional.)
•
(Optional.)

Enabling IPv6 multicast routing

Enable IPv6 multicast routing before you configure any Layer 3 IPv6 multicast functionality in the public
network or VPN instance.
To enable IPv6 multicast routing:
Step
1. Enter system view.
2. Enable IPv6 multicast routing
and enter IPv6 MRIB view.

Configuring IPv6 multicast routing and forwarding

Before you configure IPv6 multicast routing and forwarding, complete the following tasks:
• Configure an IPv6 unicast routing protocol so that all devices in the domain are interoperable at the
network layer.
Configure IPv6 PIM-DM or IPv6 PIM-SM.
•

Configuring the RPF route selection rule

You can configure the router to select the RPF route based on the longest prefix match principle. For more
information about RPF route selection, see
To configure an IPv6 multicast routing policy:
Step
1. Enter system view.
2. Enter IPv6 MRIB view.
Figure 74, a tunnel is established between the multicast routers Router A and Router B. Router
Enabling IPv6 multicast routing
Configuring IPv6 multicast routing and
Configuring the RPF route selection rule
Configuring IPv6 multicast load splitting
Configuring an IPv6 multicast forwarding boundary
forwarding:
Command
system-view
ipv6 multicast routing
[ vpn-instance vpn-instance-name ]
"RPF check process."
Command
system-view
ipv6 multicast routing
[ vpn-instance vpn-instance-name ]
248
Remarks
N/A
By default, IPv6 multicast routing is
disabled.
Remarks
N/A
N/A