Router ports (1 in total):
GE2/1/3
The output shows that GigabitEthernet 2/1/3 on Switch A has become a static router port.
# Display information about the static MLD snooping forwarding entries in VLAN 100 on Switch C.
[SwitchC] display mld-snooping static-group vlan 100
Total 1 entries).
VLAN 100: Total 1 entries).
(::, FF1E::101)
Host slots (0 in total):
Host ports (2 in total):
GE2/1/3
GE2/1/5
The output shows that GigabitEthernet 2/1/3 and GigabitEthernet 2/1/5 on Switch C have become
static member ports of the IPv6 multicast group FF1E::101.
MLD snooping querier configuration example
Network requirements
As shown in
The network is a Layer 2-only network.
•
•
Source 1 and Source 2 send multicast data to the multicast groups FF1E::101 and FF1E::102,
respectively.
Host A and Host C are receivers of multicast group FF1E::101, and Host B and Host D are receivers
•
of multicast group FF1E::102.
All host receivers run MLDv1 and all switches run MLDv1 snooping. Switch A (which is close to the
•
multicast sources) acts as the IGMP querier.
To prevent the switches from flooding unknown IPv6 packets in the VLAN, enable dropping unknown
IPv6 multicast packets on all switches.
Figure 72:
241