Configuring Mld Snooping Policies; Configuring An Ipv6 Multicast Group Filter - HP MSR2003 Configuration Manual

Setting the 802.1p precedence for MLD messages globally
Step
1. Enter system view.
2. Enter MLD-snooping view.
3. Set the 802.1p precedence for
MLD messages.
Setting the 802.1p precedence for MLD messages in a VLAN
Step
1. Enter system view.
2. Enter VLAN view.
3. Set the 802.1p precedence for
MLD messages.

Configuring MLD snooping policies

Before you configure MLD snooping policies, complete the following tasks:
Enable MLD snooping for the VLAN.
•
• Determine the ACL used as the IPv6 multicast group filter.
Determine the maximum number of IPv6 multicast groups that a port can join.
•

Configuring an IPv6 multicast group filter

When you configure an IPv6 multicast group filter, follow these guidelines:
This configuration takes effect on the IPv6 multicast groups that the port dynamically joins. If you
•
configure the port as a static member port for an IPv6 multicast group, this configuration does not
take effect on the IPv6 multicast group.
• You can configure an IPv6 multicast group filter either for the current port in interface view or
globally for all ports in MLD-snooping view. If the configurations are made in both interface view
and MLD-snooping view, the configuration made in interface view takes priority.
Configuring an IPv6 multicast group filter globally
Step
1. Enter system view.
2. Enter MLD-snooping view.
3. Configure an IPv6 multicast
group filter globally.
Command
system-view
mld-snooping
dot1p-priority priority-number
Command
system-view
vlan vlan-id
mld-snooping dot1p-priority
priority-number
Command
system-view
mld-snooping
group-policy acl6-number [ vlan
vlan-list ]
231
Remarks
N/A
N/A
The default setting is 0.
Remarks
N/A
N/A
The default setting is 0.
Remarks
N/A
N/A
By default, no IPv6 multicast group
filter is configured. A host can join
any valid IPv6 multicast group.