Configuring Ipv6 Bidir-Pim; Ipv6 Bidir-Pim Configuration Task List; Configuration Prerequisites; Enabling Ipv6 Bidir-Pim - HP MSR2003 Configuration Manual

Configuring IPv6 BIDIR-PIM

This section describes how to configure IPv6 BIDIR-PIM.

IPv6 BIDIR-PIM configuration task list

Task at a glance
(Required.)
(Required.)
•
Configuring a static RP
•
Configuring a C-RP
•
Configuring the maximum number of IPv6 BIDIR-PIM RPs
NOTE:
You must configure a static RP, a C-RP, or both in an IPv6 BIDIR-PIM domain.
In an IPv6 network without C-RPs, skip the task of configuring a BSR.
Configuring a BSR
•
(Required.)
•
(Optional.)
•
(Optional.)
(Optional.)
(Optional.)

Configuration prerequisites

Before you configure IPv6 BIDIR-PIM, configure an IPv6 unicast routing protocol so that all devices in the
domain are interoperable at the network layer.

Enabling IPv6 BIDIR-PIM

Because IPv6 BIDIR-PIM is implemented on the basis of IPv6 PIM-SM, you must enable IPv6 PIM-SM
before enabling IPv6 BIDIR-PIM. When you deploy an IPv6 BIDIR-PIM domain, HP recommends that you
enable IPv6 PIM-SM on all non-border interfaces of the domain.
IMPORTANT:
All interfaces on a device must be enabled with the same IPv6 PIM mode.
To enable IPv6 BIDIR-PIM:
Step
1. Enter system view.
2. Enable
routing and enter MRIB
view.
3. Return to system view.
Enabling IPv6 BIDIR-PIM
Configuring an RP:
Configuring a C-BSR
Configuring an IPv6 PIM domain border
Disabling the BSM semantic fragmentation function
Configuring common IPv6 PIM features
Enabling SNMP notifications for IPv6 PIM
Command
system-view
IPv6 multicast
ipv6 multicast routing [ vpn-instance
vpn-instance-name ]
quit
Remarks
N/A
By default, IPv6 multicast routing is
disabled.
N/A
301