Configuring Bgp As Number Substitution And Soo Attribute; Enabling Snmp Notifications For Mpls L3Vpn - HP MSR2000 Configuration Manual

Step
1. Enter system view.
2. Enter BGP view.
3. Specify
processing mode as POPGO
forwarding.
Configuring BGP AS number substitution and SoO
attribute
When CEs at different sites have the same AS number, configure the BGP AS number substitution function
to avoid route loss.
When a PE uses different interfaces to connect different CEs in a site, the BGP AS number substitution
function introduces a routing loop. To remove the routing loop, configure the SoO attribute on the PE.
For more information about the BGP AS number substitution function and the SoO attribute, see
number substitution and SoO
To configure BGP AS number substitution and SoO attribute:
Step
1. Enter system view.
2. Enter BGP view.
3. Enter BGP-VPN instance view.
4. Enable the BGP AS number
substitution function.
5. Enter BGP-VPN IPv4 unicast
address family view.
6. (Optional.) Configure the SoO
attribute for a BGP peer or
peer group.
For more information about the commands in this section, see Layer 3—IP Routing Command Reference.

Enabling SNMP notifications for MPLS L3VPN

This feature enables MPLS L3VPN to generate SNMP notifications. The generated SNMP notifications
are sent to the SNMP module.
For more information about SNMP notifications, see Network Management and Monitoring
Configuration Guide.
To enable SNMP notifications for MPLS L3VPN:
Step
1. Enter system view.
Command
system-view
bgp as-number
the VPN label
vpn popgo
attribute."
Command
system-view
bgp as-number
ip vpn-instance vpn-instance-name
peer { ip-address | group-name }
substitute-as
address-family ipv4 [ unicast ]
peer { group-name | ip-address }
soo site-of-origin
Command
system-view
216
Remarks
N/A
N/A
The default is POP forwarding.
Remarks
N/A
N/A
N/A
By default, BGP AS number
substitution is disabled.
N/A
By default, the SoO attribute is not
configured.
Remarks
N/A
"BGP AS