HP MSR2000 Configuration Manual page 294

Figure 73 Network diagram
Configuration procedure
Assume that:
The system name of the MCE device is MCE.
•
The system names of the edge routers of VPN 1 and VPN 2 are VR 1 and VR 2, respectively.
•
The system name of PE 1 is PE1.
•
1. Configure VPN instances on the MCE and PE 1:
# On the MCE, configure VPN instances vpn1 and vpn2, and specify an RD and route targets for
each VPN instance.
<MCE> system-view
[MCE] ip vpn-instance vpn1
[MCE-vpn-instance-vpn1] route-distinguisher 10:1
[MCE-vpn-instance-vpn1] vpn-target 10:1
[MCE-vpn-instance-vpn1] quit
[MCE] ip vpn-instance vpn2
[MCE-vpn-instance-vpn2] route-distinguisher 20:1
[MCE-vpn-instance-vpn2] vpn-target 20:1
[MCE-vpn-instance-vpn2] quit
# Bind interface GigabitEthernet 2/1/1 to VPN instance vpn1, and configure an IP address for the
interface.
[MCE] interface gigabitethernet 2/1/1
[MCE-GigabitEthernet2/1/1] ip binding vpn-instance vpn1
285