HP MSR2000 Configuration Manual page 232

[PE1-ospf-1] quit
# Configure the P device.
<P> system-view
[P] interface loopback 0
[P-LoopBack0] ip address 2.2.2.9 32
[P-LoopBack0] quit
[P] interface pos 2/1/0
[P-Pos2/1/0] ip address 172.1.1.2 24
[P-Pos2/1/0] quit
[P] interface pos 2/1/1
[P-Pos2/1/1] ip address 172.2.1.1 24
[P-Pos2/1/1] quit
[P] ospf
[P-ospf-1] area 0
[P-ospf-1-area-0.0.0.0] network 172.1.1.0 0.0.0.255
[P-ospf-1-area-0.0.0.0] network 172.2.1.0 0.0.0.255
[P-ospf-1-area-0.0.0.0] network 2.2.2.9 0.0.0.0
[P-ospf-1-area-0.0.0.0] quit
[P-ospf-1] quit
# Configure PE 2.
<PE2> system-view
[PE2] interface loopback 0
[PE2-LoopBack0] ip address 3.3.3.9 32
[PE2-LoopBack0] quit
[PE2] interface pos 2/1/0
[PE2-Pos2/1/0] ip address 172.2.1.2 24
[PE2-Pos2/1/0] quit
[PE2] ospf
[PE2-ospf-1] area 0
[PE2-ospf-1-area-0.0.0.0] network 172.2.1.0 0.0.0.255
[PE2-ospf-1-area-0.0.0.0] network 3.3.3.9 0.0.0.0
[PE2-ospf-1-area-0.0.0.0] quit
[PE2-ospf-1] quit
# On PE 1, verify that the PEs have learned the routes to the loopback interfaces of each other.
[PE1] display ip routing-table protocol ospf
Summary Count : 5
OSPF Routing table Status : <Active>
Summary Count : 3
Destination/Mask
2.2.2.9/32
3.3.3.9/32
172.2.1.0/24
OSPF Routing table Status : <Inactive>
Summary Count : 2
Proto Pre Cost
OSPF 10 1
OSPF 10 2
OSPF 10 2
223
NextHop Interface
172.1.1.2 Pos2/1/0
172.1.1.2 Pos2/1/0
172.1.1.2 Pos2/1/0