Configuring Ipv6 Mpls L3Vpn Inter-As Option A - HP MSR2000 Configuration Manual

# Execute the display bgp peer vpnv6 command on the PEs. This example uses PE 1 to verify that
a BGP peer relationship in Established state has been established between the PEs.
[PE1] display bgp peer vpnv6
BGP local router ID : 1.1.1.9
Local AS number : 100
Total number of peers : 1
Peer
2.2.2.9
6. Configure a GRE tunnel:
# Configure PE 1.
[PE1] interface tunnel 0 mode gre
[PE1-Tunnel0] source loopback 0
[PE1-Tunnel0] destination 2.2.2.9
[PE1-Tunnel0] ip address 20.1.1.1 24
[PE1-Tunnel0] mpls enable
[PE1-Tunnel0] quit
# Configure PE 2.
[PE2] interface tunnel 0 mode gre
[PE2-Tunnel0] source loopback 0
[PE2-Tunnel0] destination 1.1.1.9
[PE2-Tunnel0] ip address 20.1.1.2 24
[PE2-Tunnel0] mpls enable
[PE2-Tunnel0] quit
Verifying the configuration
# Verify that the CEs have learned the route to each other and can ping each other. (Details not shown.)

Configuring IPv6 MPLS L3VPN inter-AS option A

Network requirements
CE 1 and CE 2 belong to the same VPN. CE 1 accesses the network through PE 1 in AS 100 and CE 2
accesses the network through PE 2 in AS 200.
Configure IPv6 MPLS L3VPN inter-AS option A, and use VRF-to-VRF method to manage VPN routes.
Run OSPF on the MPLS backbone of each AS.
Peers in established state : 1
AS MsgRcvd MsgSent OutQ PrefRcv Up/Down
100 3
338
3 0 1 00:00:34 Established
State