HP MSR2000 Configuration Manual page 338

[PE2-LoopBack0] quit
[PE2] interface pos 2/1/0
[PE2-Pos2/1/0] ip address 172.2.1.2 24
[PE2-Pos2/1/0] quit
[PE2] ospf
[PE2-ospf-1] area 0
[PE2-ospf-1-area-0.0.0.0] network 172.2.1.0 0.0.0.255
[PE2-ospf-1-area-0.0.0.0] network 3.3.3.9 0.0.0.0
[PE2-ospf-1-area-0.0.0.0] quit
[PE2-ospf-1] quit
# On PE 1, verify that the PEs have learned the routes to the loopback interfaces of each other.
[PE1] display ip routing-table protocol ospf
Summary Count : 5
OSPF Routing table Status : <Active>
Summary Count : 3
Destination/Mask
2.2.2.9/32
3.3.3.9/32
172.2.1.0/24
OSPF Routing table Status : <Inactive>
Summary Count : 2
Destination/Mask
1.1.1.9/32
172.1.1.0/24
# On PE 1, verify that OSPF adjacencies in Full state have been established between PE 1, P, and
PE 2.
[PE1] display ospf peer verbose
OSPF Process 1 with Router ID 1.1.1.9
Area 0.0.0.0 interface 172.1.1.1(POS2/1/0)'s neighbors
Router ID: 2.2.2.9
State: Full
DR: 172.1.1.2
Options is 0x02 (-|-|-|-|-|-|E|-)
Dead timer due in 39
Neighbor is up for 00:00:29
Authentication Sequence: [ 0 ]
Neighbor state change count: 6
2. Configure basic MPLS and enable MPLS LDP on the MPLS backbone to establish LDP LSPs:
# Configure PE 1.
[PE1] mpls lsr-id 1.1.1.9
Proto Pre Cost
OSPF 10 1
OSPF 10 2
OSPF 10 2
Proto Pre Cost
OSPF 10 0
OSPF 10 1
Neighbors
Address: 172.1.1.2
Mode: Nbr is Master
BDR: 172.1.1.1 MTU: 0
sec
329
NextHop
172.1.1.2
172.1.1.2
172.1.1.2
NextHop
1.1.1.9
172.1.1.1
GR State: Normal
Priority: 1
Interface
POS2/1/0
POS2/1/0
POS2/1/0
Interface
Loop0
POS2/1/0