HP MSR2000 Configuration Manual page 420

4. Configure PE 2:
# Configure an LSR ID.
<PE2> system-view
[PE2] interface loopback 0
[PE2-LoopBack0] ip address 192.3.3.3 32
[PE2-LoopBack0] quit
[PE2] mpls lsr-id 192.3.3.3
# Enable L2VPN.
[PE2] l2vpn enable
# Configure GigabitEthernet 2/1/2 (the interface connected to the P device), and enable MPLS on
the interface.
[PE2] interface gigabitethernet 2/1/2
[PE2-GigabitEthernet2/1/2] ip address 10.2.2.1 24
[PE2-GigabitEthernet2/1/2] mpls enable
[PE2-GigabitEthernet2/1/2] quit
# Configure OSPF.
[PE2] ospf
[PE2-ospf-1] area 0
[PE2-ospf-1-area-0.0.0.0] network 10.2.2.0 0.0.0.255
[PE2-ospf-1-area-0.0.0.0] network 192.3.3.3 0.0.0.0
[PE2-ospf-1-area-0.0.0.0] quit
[PE2-ospf-1] quit
# Create a cross-connect group named ccc, create a remote CCC connection that has incoming
label 202, outgoing label 102, and next hop 10.2.2.2, and bind GigabitEthernet 2/1/1 to the
CCC connection.
[PE2] xconnect-group ccc
[PE2-xcg-ccc] connection ccc
[PE2-xcg-ccc-ccc] ccc in-label 202 out-label 102 nexthop 10.2.2.2
[PE2-xcg-ccc-ccc] ac interface gigabitethernet 2/1/1
[PE2-xcg-ccc-ccc] quit
[PE2-xcg-ccc] quit
5. Configure CE 2.
<CE2> system-view
[CE2] interface gigabitethernet 2/1/1
[CE2-GigabitEthernet2/1/1] ip address 100.1.1.2 24
[CE2-GigabitEthernet2/1/1] quit
Verifying the configuration
# Display L2VPN PW information on PE 1. The output shows that a remote CCC connection (identified by
PW ID/Rmt Site "-" and Proto Static) has been established.
[PE1] display l2vpn pw
Flags: M - main, B - backup, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 1, 1 up, 0 blocked, 0 down, 0 defect
Xconnect-group Name: ccc
Peer
10.1.1.2
PW ID/Rmt Site In/Out Label
- 101/201
Proto
Static
411
Flag Link ID State
M 0 Up