NEC Express5800 series User Manual page 109

B
A
B
Figure 4-20. Installing and Removing a Non-Hot-Plug PCI Add-In Board
8. Insert the board into the front and rear retention mechanisms. Carefully push
down on the board until it engages and fully seats in the slot connector.
9. Close the front and rear latches on the front and rear retention mechanisms.
10. Install the system board access cover and the rear access cover.
11. Turn on any peripheral devices connected to the system.
12. Plug in the power cords and power up the system. Make sure that POST
does not display an error message. If an error message appears, write down
the message and review the error message list in Chapter 5.
13. Start the BIOS Setup Utility to set the "Reset Configuration Data" in the
"Advanced" menu to "Yes." This is required to update the hardware
configuration information. See Chapter 3 for details.
Latch, rear retention mechanism
Latch, front retention mechanism
A
Upgrading Your System 4-27