Installing The Processor Board Air Baffle - NEC Express5800 series User Manual

Installing the Processor Board Air Baffle

To install the processor board air baffle:
1. Position the baffle so that the two release tabs (A) are toward the rear of the
chassis (Figure 4-8).
2. With the rear of the air baffle raised, insert the tab on the front of the air
baffle into the slot in the chassis. Holding the baffle at an angle of about 30°
will allow the tab to engage correctly.
3. Rotate the rear end of the baffle down. Adjust the position of the baffle until
it moves into place and the two tabs are engaged. Be sure to avoid
interference with the CPU retention modules. Do not force it down.
4. Install the memory board following procedures previously described in this
chapter.
5. Install the system board access cover and rear access cover following
procedures previously described in this chapter.
6. Plug in the AC power cords and power on the system.
4-12 Upgrading Your System
A
Figure 4-8. Installing the Air Baffle