Scsiselect Utility; Running The Scsiselect Utility - NEC Express5800 series User Manual

SCSISelect Utility

The SCSISelect Utility detects the SCSI host adapters on the system I/O board
and on option SCSI controller boards.
The SCSISelect Utility is used mainly to set the transfer rate of connected SCSI
device. Use the SCSISelect Utility to:
!
Change default values
!
Check and/or change SCSI device settings that may conflict with those of
other devices in the server

Running the SCSISelect Utility

You access the Adaptec SCSI Utility when you turn on or reboot your system.
To run the Adaptec SCSI utility, perform the following procedure:
1. Power-on or reboot the system.
2. The following message appears on the video monitor:
Press Ctrl-A for SCSISelect ™ Utility!...
3. Press Ctrl+A to run this utility. When the Main menu appears, choose the
host adapter that you want to configure.
Note:
controller channels. Channel A indicates the Ultra 160 SCSI
connector (for hard disks); and Channel B indicates the Ultra
160 SCSI connector (for 5.25-inch devices and external
SCSI devices).
4. Select a channel and press ENTER.
5. Once you select the adapter, the following screen is displayed:
Menu
Configure/View Host
Adapter Settings
SCSI Disk Utilities
6. If you wish to format a disk, verify disk media, or display a list of devices
and their SCSI Ids, select "SCSI Disk Utilities". If you wish to configure the
adapter or a device, select "Configure/View Host Adapter Settings".
The system in your server includes two SCSI
Description
Configure host adapter and device settings.
The utility scans the SCSI bus for SCSI devices, reports a
description of each device. Run these utilities before
configuring SCSI devices.
Configuring Your System 3-21