NEC Express5800 series User Manual page 152

Table 5-1. POST Error Codes and Messages (continued)
Error Code and Message
0BE8 IPMB device address
error
0BE9 IPMB device error
0BEA IPMB timeout
8100 Memory error DIMM
Group #1
8101 Memory error DIMM
Group #2
8102 Memory error DIMM
Group #3
8120 Unsupported DIMM
detected in DIMM
Group #1
8121 Unsupported DIMM
detected in DIMM
Group #2
8122 Unsupported DIMM
detected in DIMM
Group #3
8130 Mismatch DIMM
detected in DIMM
Group #1
8131 Mismatch DIMM
detected in DIMM
Group #2
8132 Mismatch DIMM
detected in DIMM
Group #3
8140 DIMM Group #1 with
error is enabled
8141 DIMM Group #2 with
error is enabled
8142 DIMM Group #3 with
error is enabled
8150 NVRAM cleared by
jumper
8151 Password cleared by
jumper
8160 Mismatched processor
speed detected on
processor #1
8161 Mismatched processor
speed detected on
processor #2
5-20 Problem Solving
Description
IPMB device address not
acknowledged
IPMB device error detected
IPMB timeout
Memory error detected in
DIMM Group #1
Memory error detected in
DIMM Group #2
Memory error detected in
DIMM Group #3
Unsupported DIMM detected in
DIMM Group #1
Unsupported DIMM detected in
DIMM Group #2
Unsupported DIMM detected in
DIMM Group #3
Mismatch DIMM detected in
DIMM Group #1
Mismatch DIMM detected in
DIMM Group #2
Mismatch DIMM detected in
DIMM Group #3
DIMM Group #1 with error is
enabled
DIMM Group #2 with error is
enabled
DIMM Group #3 with error is
enabled
NVRAM cleared by jumper
Password cleared by jumper
Mismatched processor speed
detected on processor #1
Mismatched processor speed
detected on processor #2
Action
Contact your service representative
Contact your service representative to
replace the four DIMMs in the relevant
group.
See the labels put on the DIMMs to make
sure that DIMMs of the same type are
installed in groups. If DIMMs of different
types are installed in one or more groups,
contact the service representative to replace
DIMMs properly.
Contact your service representative to
replace the four DIMMs in the relevant
group.
Turn OFF the power. Then reset the jumper
setting to the original position.
Check the frequency of the CPU. If it is
unknown, contact your service
representative.